The OpenWrt section (README stub)
Working material for #write-the-openwrt-section: the lean section both
READMEs carry, routing to the full guide. Per the operator ruling of
2026-11-13 it documents deployment from the release assets only.
EN
Running on OpenWrt
The release binaries are built with the OpenWrt target toolchains and run on
a stock router: static, about 4.2 MB, no kernel modules, with a receive path
that falls back where the kernel lacks io_uring. Copy the asset for your
target (the which-binary table maps them), and the guide turns it into an
appliance: a procd service that starts at boot, restarts on exit, and reads
/etc/config/udpspeeder-simd, so every UCI stanza in this documentation
works verbatim; uci commit applies changes, logread shows the loss
report, and one line in /etc/sysupgrade.conf carries the binary across
firmware upgrades. The whole story, with the init script ready to paste:
doc/openwrt.md.
zh
在 OpenWrt 上运行
发布二进制由 OpenWrt 目标工具链构建,在原厂路由器上直接可用:静态链接,约 4.2 MB,无需内核模块;内核缺少 io_uring 时收包路径自动回退。按目标机型选好资产(见哪台机器用哪个二进制一节的对照表),再由指南把它变成一个设备级服务:procd 守护开机自启、退出即重启,并读取 /etc/config/udpspeeder-simd,因此本文档中所有 UCI 配置段均可原样使用;uci commit 即时生效,logread 查看丢包报告,/etc/sysupgrade.conf 加一行即可让二进制随固件升级保留。完整过程与可直接粘贴的 init 脚本见 doc/openwrt.md。